Brainstorm Electronics DXD-8

The DXD series from Brainstorm is designed to ease the transition to IP. The DXD-8 Universal Clock, a precision multiformat reference generator generates up to 4 independent video syncs and audio clocks simultaneously. With the PTP option, it acts as a bridge between an IP infrastructure and legacy A/V equipment. Customize your units with universal outputs. The DXD-8 generates up to 4 independent sync pulses and clocks simultaneously and routes them to the 8 BNC universal outputs. Universal Outputs give the DXD-8 great exibility as they can output any of the generated legacy reference signals. Included are all standard SD and HD video sync formats (Black Burst and HD tri-level sync), word clock and AES11 DARS (standard rates up to 384 KHz and all the necessary pull-up/down, including 24:25 conversions, even VSO) and 10MHz. Accurate and versatile clock generator. A high-accuracy internal crystal oscillator (TCXO) provides a very stable frequency reference (+/- 1ppm). An optional oven-controlled oscillator (OCXO) can be installed. External legacy signals can also be used as reference, such as Word Clock, AES, Video Sync (SD & HD) or a 10MHz tone. The generated outputs have extremely low jitter. The output rates are independent from the reference rate which means that any rate can be extracted from any reference such as 59.97 from 25FPS for example. IEEE 1588 network sync. Optional firmware can be installed to give PTP capabilities to the DXD-8, compliant with IEEE 1588 PTP V2. The DXD- 8 can be either a PTP master or slave Clock. PTP (Precision Time Protocol), defined in IEEE 1588, has been broadly adopted by manufacturers as a network synchronizing standard, which means that the DXD-8 can work in a number of systems. PTP profiles supported by the DXD-8 include AES67 and SMPTE 2059. As a PTP slave, the DXD-8 would synchronize its internal clocks to the PTP Grandmaster while generating the different sync pulses and clocks. Alternatively it can itself fulfill the function of Grandmaster either locked to the GPS signal (option) or to it’s internal oscillator. The DXD-8 has one Gigabit Ethernet port (RJ45). GNSS / GPS. A GNSS/GPS receiver can be installed as an option in the DXD-8 and provide the highly accurate and stable GPS clock as a timing source. Multiple DXD’s in remote locations will be locked to each other and in phase once they are GPS referenced. Resilience and redundancy. When using an external reference, a second source can be connected as fallback in case of failure. If the external reference becomes unusable, the DXD-8 continues generating, locked either to the alternate source or to the internal oscillator and re-locks to the reference when it reappears. These transitions occur smoothly and gradually with no sync shock to the system. Two external 12VDC power supply can be connected to the DXD-8. It can operate with either of these power sources and they can both act as a back-up for the other with auto switch-over in the event of a failure.